How To Assemble - Tectake 405083 Bedienungsanleitung

Description (fig. 1)
1.Product frames
2.Seat fabric covering
3.Toy bar
4.Cushion
5.Seat frames
6.Cushion fastening
7.USB cable

How to assemble

1.Unfold the legs of the baby swing so that they are stable on the flat surface.
2.Put the sound module on the frame of the baby swing, as showed in the figure no.2.
3.The assembly is successful if you can hear a „click".
4.Lift frames of the seat (5) and then put the fabric covering on it (fg. 3). Fasten the Velcro at
the bottom of the covering.
How to replace a battery
1.Use a screwdriver to loosen the bolt which secures the battery compartment(fig. 4).
2.Remove the battery cover and insert four LR14 batteries in the compartment. Pay special
attention to battery poles (see: fig. 5).It is advisable to use alkaline batteries.
3.Put the battery cover on and tighten up with a screwdriver. Do not tighten up too
firmly (fig. 6).
Feeder cable
To use the mains power supply, connect a USB cable to the sound module of the baby swing (port
marked as e in fig. 13). Insert the second tip in the relevant mains power adapter (not supplied).
Note! The feeder cable should have the following parameters:
input: 100-240V~50/60Hz 0.3A,output: 5V
How to use the product
Cushion - the product is equipped with a high-quality cushion which can be attached to the
covering with a Velcro (6) located underneath the cushion. To do so, pull the cushion Velcro
through a fastening which stands out from the seat (fig. 7) and fasten it.
5- point safety belts - when the child is in the baby swing, safety belts must always be
fastened.
A.To fasten the belts:
1.Put the child into the baby swing. Make sure your child's legs go through the protective fabric
cushion, as presented in fig. 11.
2. Insert the tip of shoulder belts (A in fig. 8) in hip belts (B in fig. 8). Pull
child's hands through them.
3. When the belts are connected, insert them in the buckle (C in fig. 8). If you can hear a click",
it means the assembly has been successful.
4. After you have fastened the belts, put the protection on the buckle (fig. 9)
B. To undo the belts: press the key on the buckle and pull the belts out (fig. 10).
C. How to adjust the belts
Adjust the belts to your child's body with the use of adjustment. The belts must fit tight your
child's body but must not cause discomfort. The belts must not be twisted.
You can also change the height of shoulder belts. To do so, undo the belts and take them out
through holes in the seat covering (marked in fig. 12). Next pull the belts through another hole
and secure them on the other side of the covering.
1000mA.
6