Installing The In-Room Emergency Pushbutton Unit; Operation And Maintenance; Spare Parts - Pego ECPAPE03 Bedienungsanleitung

ECPAPE03
2.2
1. The in-room pushbutton must be positioned so that it is always visible and easily
reachable.
2. Undo the two closure screws on the front of the pushbutton panel.
3. Using the two internal holes fix the box backing with three screws of a length suitable for
the thickness of the wall to which it is to be attached.
2.3
Carry out the connections as per the wiring diagram.
-
After initial connection it will take 110 hours to fully charge the battery.
-
Press the luminous pushbutton installed inside the cold room to activate the
-
acoustic and luminous warning devices on the external alarm control unit.
The auxiliary relay contact closes.
- In the event of a 230 V AC power failure the buffer battery will intervene and power
the system for the duration indicated on the technical characteristics chart.
- Reset the emergency switch inside the cold room to cancel the alarm.
- Periodically check that the buffer battery is working properly.
- If the battery is replaced make sure it is disposed of properly at an authorised waste
collection facility.
- If the alarm is tripped without the pushbutton being pressed check the connection
lead and the connections between the pushbutton and external control unit.

SPARE PARTS:

Buffer battery: ACC12VNIMH
USE AND MAINTENANCE MANUAL
Pag.18
- ENG -
INSTALLING THE IN-ROOM EMERGENCY PUSHBUTTON

OPERATION AND MAINTENANCE

CHAP. 2 - Installation
Rev. 1-09