Trust START-LINE ACM-100 Bedienungsanleitung Seite 14

7. Connecting a neutral wire to [NI
Connect a (blue) neutral wire to the right-hand
most cases, a neutral wire will not be present in a single wall switch. If this is the case, a neutral wire
must be laid to the switch.
8. Switching on the power
Switch the power back on before carrying on with the installation
wiring. he LED indicator light on the receiver will light up continuously
9. Setting the dimming range
YOU must set the right dimming
lighting. The ACM-IOO is equipped with two setting dials marked from 1 to 4.
10. Important note
To assure correct dimming of dimmable
first. Immediately afterwards,
11. Setting the dimming range for dimmable
Now slowly turn the dial backwards
time you change the posltion of the dial, the lighting will operate at full intensity first. Then it will dim
automatically to the set value.
12. Setting the dimming range
As soon as you see that the dimming value is not acceptable (the lighting starts to flicker or goes out),
turn the dial to the lowest position at which the dimming value operates correctly. That is position 3 in
this example.
13. Setting the dimming range for other liqhts
Now slowly turn the dial backwards
time you change the position Of the dial, the lighting will dim automatically
[N] terminal (IN]. Tighten up the terminal screws. In
range first in order to achieve optimal dimming of the connected
ESC,this dimme
the lights are set to the dim-level that you have chosen.
ESL
one step at a time. so from 4 to 3 first, then from 3 to 2, etc. Each
one step at a time. so from 4 to 3 first, then from 3 to 2, etc. Each
ACM-IOO BUILD-IN MULTI
work. Avoid contact with exposed
if a voltage is present.
always sw•tches to full brightness
to the set value.
DIMMER
(100%)
2