Functional Check; Maintenance; Regular Cleaning Of The Anti-Static Bar; Cleaning A Heavily Fouled Anti-Static Bar - Simco-Ion Performax Easy Bedienungsanleitung

7. Functional check

The colour of the status LED on the anti-static bar and of the LEDs on the optional cable
connector can be used to determine the status of the anti-static bar.
Operation
Standby
In operation
Overloaded
HV OK signal overload
Possible causes of overload are:
- Fouling of the anti-static bar.
- Direct contact between conductive material and the emitters.
- The anti-static bar has been fitted too close to conductive (machine) parts.
Possible causes of HV OK overload are:
- Short circuit of the HV OK signal
- Excessive load of the HV OK signal

8. Maintenance

Warning:
- Disconnect the power supply before carrying out work on the unit.

8.1. Regular cleaning of the anti-static bar

- Clean the emitter points and the anti-static bar regularly with a hard, non-metal brush.
Warning:
- The emitters are sharp and can cause physical injury.

8.2. Cleaning a heavily fouled anti-static bar

- Clean the anti-static bar using a suitable cleaning agent (such as isopropyl alcohol).
Veconova 10 may also be used in the event of stubborn fouling (www.eco-nova.nl)
- Allow the anti-static bar to dry completely before operating it again.
Performax Easy/Performax Easy Speed_UM_9752152130_NL_D_GB_F_V3_0
Bar LED
Green flashing
Green on Green, white and orange on
Red on
Red flashing
Connector LED
Green on
Green and white on
Green and white on
36