Werbung
Verfügbare Sprachen
Verfügbare Sprachen
!
BEFORE USE
Pair your remote
When you connect your fan to the network for the first 30 seconds, a pairing channel
is opened. To pair your fan, press and hold the power button for 5 seconds in the 30
second period.
The fan responds with a long beep. To pair multiple fans with the same remote
control, repeat the operation with each fan. Your fan is now paired.
Configuring the remote control
This universal remote control is suitable for Klassfan ceiling fans, and must be
configured according to the characteristics of your fan model, depending on the
material and dimensions of the fan blades.
Please check the blade model of your fan and set the remote control with the
appropriate program according to the table on the next page, to ensure the correct
operation and the highest efficiency of the ceiling fan.
CONFIGURATION STEPS:
1.
Press the power button to stop the fan.
2.
Longpress the configuration button (backside left on the remote control). When
you hear a long "BEEP" its entered the configuration mode.
3.
Short press the speed button according to the blades of your fan, 6 speed level
matching 6 firmware. Confirming the last selection.
4.
Long press the power button, the fan emits long "BEEPS". Setting is finished.
* NOTE:
Please do not press any other button during configuration, otherwise the
configuration will stop.
A PROGRAM ERROR CAN CAUSE
IRREVERSIBLE DAMAGE TO YOUR FAN!
Speed 1
Speed 2
3
4
Speed 3
2
5
Speed 4
Speed 5
1
6
Speed 6
PROGRAM 1
PROGRAM 2
PROGRAM 3
PROGRAM 4
PROGRAM 5
PROGRAM 6
16
Werbung
