Shark PowerDetect IP1000 Serie Bedienungsanleitung Seite 29

MAINTAINING YOUR VACUUM
CLEANING THE SENSORS
Make sure to clean the Detect sensors regularly, as hair and other debris may build up and
obstruct them� If the sensors are partially obstructed, Clean Sense Detect mode will not function
as expected�
To clean the sensors:
1. Turn off power and remove the floor nozzle�
2. Locate the Dirt Detect Sensor (Fig� 1), the Light Detect Sensor on (Fig� 2), the Edge Detect
sensor (Fig� 3) and the Floor Detect Sensor (Fig� 4)�
3. Gently wipe the sensors with a microfibre cloth and remove all hair and debris�
4. Reattach the floor nozzle to the rest of the unit and turn on power� Verify that the unit is
functioning normally�
Fig. 1
DIRTDETECT-SENSOR
Fig. 3
EDGEDETECT-SENSORER
16
sha rkclean.eu
Fig. 2 Fig. 2
LIGHTDETECT-SENSORER
Fig. 4
FLOORDETECT-SENSORER
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES IN THE VACUUM
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll�
Checking for Blockages in
Checking for Blockages in the
the Wand:
Hand Vacuum:
1. Turn off the vacuum�
1. Turn off the vacuum�
2. Detach the hand vacuum and
2. Remove the hand vacuum from the
floor nozzle from the wand�
wand�
3. Check both ends of the wand for
3. Check all intake openings to the
blockages and debris�
dust cup and remove any debris
or blockages� 4. Clear away any debris or
blockages�
Checking for Blockages in the
Floor Nozzle:
1. Turn off the vacuum�
2. Detach the wand from the floor
nozzle�
3. Press the soft roller release
button and slide the brushroll
out of the nozzle�
4. Clear any blockages and release
any debris from the brushroll
and floor nozzle�
5. Slide the soft roller back into the
nozzle, ensuring everything is
lined up and in place�
17
s ha rkc l ea n.eu