EuroLite FOGGLES Bedienungsanleitung Seite 20

Fluid handling
Always disconnect from the mains before filling the machine. Only use water-based fluids. Never add
flammable liquids. If fluid gets inside the machine, have it checked by skilled personnel before it is
operated.
The following fluids are optimized for use in the machine. Only use high-quality fluids recommended by your
dealer to assure satisfactory results. The use of unapproved fluid can damage the machine.
No. 51705316
No. 51703798
Bubble fluid only
Unscrew the housing screws and remove the cover. Remove the tank containers, unscrew the covers and fill in
the respective fluid type. Close the containers again, insert them into the machine and screw the cover back on.
Operating conditions
Before mounting the product, read and follow the chapter Safety Instructions.
This product may not be tilted. This product should be level at all times.
• Remove all packing materials from the shipping box. Make sure that there are no packing remnants at the output
nozzle.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• Keep a minimum distance of 20 cm around and above the device.
• Only install the fog machine on scratch resistant and water resistant surfaces.
• Do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to create a good
effect, there should be a distance between the device and the audience of at least 1.5 m.
• The bubbles leave a slippery surface; consider this when installing your machine.
FLUID
WARNING!
Bubble Fluid PRO 2.5l
Smoke Fluid -C2D- Standard 5l
MOUNTING
CAUTION!
20 • EN
Fog fluid only
Unscrew housing screws