28. Never place this appliance on or near a hot gas or an electric burner or where it could touch a heated
appliance.
29. Be careful if hot liquid is poured into the food processor or blender as it can be ejected out of the appliance
due to a sudden steaming.
30. Regarding the instructions for cleaning the surfaces which come in contact with food, speed settings and
operating times, please refer to the below paragraph of the manual.
FEATURES
1. Measuring cup
2. Lid
3. Jar
4. Blade assembly
5. Motor base
6. Low speed button
7. High speed button
8. Base foot
HOW TO USE
Caution: Make sure the motor base is unplugged from the power source.
1.
Clean the blender according to the instructions in the "CLEANING AND MAINTENANCE" section.
2.
Place the jar onto the motor base. Align the mark "▽" on the jar with "
the jar clockwise to have it locked on the motor base. The blender will not work if the jar isn't locked into
the motor base properly.
3.
Put the liquid and diced food into the jar. The recommended ratio of the liquid and diced food shall be 3:2
and never fill the jar with ingredients that exceed 50°C.
4.
Put the lid onto the jar; align and rotate to lock the lid. Insert the measuring cup into the middle of the lid.
5.
Put the plug into the power outlet. Switch on the appliance by pressing the low or high speed button
according to the blending task.
6.
After use, remove the plug from the outlet.
Note:
For quick or delicate blending tasks, press the high speed button and hold it for a few seconds. Operate
several times until the consistence you want is obtained.
For each use, the consecutive operation time should not exceed 1 minute. At least 10 minutes of rest time
must be maintained between two continuous cycles; let the appliance cool to room temperature before
performing next operation cycle.
When crushing ice or hard food, keep one hand firmly on the lid.
If you want to add ingredients while the blender is working, just open the measuring cup and add the
ingredients through the opening.
CAUTION
•
Never use boiling liquids.
•
Never run the blender empty or with solids only.
- 3 -
" on the motor base, then rotate