Rupes RP84 Original-Bedienungs- Und Wartungsanleitung Seite 11

PARTS OF THE TOOL
1 - Identification plate
2 - ON-OFF switch
3 - Handle
4 - Auxiliary handle
5 - Auxiliary handle fixing screw
6 - Slot for accessories
7 - Plate with straight or adjustable guide or roller
8 - Depth guide black plate
9 - Positioning device for trimming and relative fixing screws
10 - Plate with guide slot cutting
11 -Guide for slot cutting
12 -Wide cutter guide
13 -Cutter
14 -Collet shaft
15 -Tool collet
16 -Collet tightening nut
17 -Motor ventilation slots
18 -Filter support grid
19 -Dust filter
20 -Spanners
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been da-
maged during storage or transport;
- the tool is complete; check that the number and type of components com-
ply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in the-
table and that indicated on the tool identification plate reproduced and
explained on page 11.
ASSEMBLING THE TOOL
- Assemble the auxiliary handle (4) using the fixing screw (5);
- place the dust filter (19) in the grid (18) and mount the unit on the toolbody;
- assemble the accessories required for the operation to carry out.
ASSEMBLING THE CUTTERS
- The cutters should be fitted before or after the accessories depending on
which accessories are used;
- slacken the lock nut (16) and insert the tang of the cutters in the collet (15);
- keep the collect (14) still using the spanner supplied and tighten the
locknut (16) ensuring that the cutters is centred and tight.
CUTTERS REPLACEMENT
- Slacken the lock nut (16) using the spanner supplied, keeping the collet
shaft still;
- replace the cutters and re-tighten.
FITTING ACCESSORIES
FOR TRIMMING EDGES
- Assemble accessories (7) and (8) in the slots (6) and fix them in position
using the spring washer and screws supplied;
- use either the straight guide or roller for straight, curved for irregular
edges;
- adjust the cutters using adjuster (9) and tighten the relative screws.
FOR CUTTING SLOTS
- If necessary, replace the cutter guide on the guide plate (7) with one of
large diameter (12);
- fit a cutter of suitable dimensions;
- if necessary, fit and position the guide and adjustment device (11).
USABLE WORKING TOOLS
Cutters with 6 mm Ø.
BEFORE STARTING THE TOOL
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly though with the power supply discon-
nected;
- all the parts of the tool have been assembled in the proper manner and that
there are no signs of damage;
- the ventilation slots are not obstructed (17);
- the cutters is properly fixed (13).
STARTING AND STOPPING
- Starting: push the slide of the ON/OFF switch (2) forward.
- Stopping: return the switch (2) to its original position.
TEST RUN
Start the tool and check that there is no vibration and that the cutters iscen-
tred.
Otherwise switch-off the tool immediately and eliminate the cause.
11