Cleaning And Care - Rondell Rde-1850 Die Betriebsanweisung

ENGLISH
Auto reminder function
At the end of the set program, the display (9) will show the
«End» icon, and you will hear 3 sound signals. The reminder
signal will be repeated every 3 minutes until you press the
«Pause/Stop» button (12) or open the oven door.

CLEANING AND CARE

• Switch the unit off and unplug it before cleaning.
• Provide that water does not get on the unit control panel,
clean it with a soft, slightly damp cloth and then wipe it dry.
• Keep the oven cavity clean. When food splatters or
spilled liquids stick to oven walls, remove them careful-
ly using a damp cloth.
• If the oven cavity is dirty, use a soft detergent.
• Do not use abrasives or wire brushes to clean the outer
and inner surfaces of the unit. Provide that no water or
detergent gets into the air and steam outlets on the unit
cover and body.
TROUBLES AND TROUBLESHOOTING
The unit makes interferences in the
reception of TV and radio signals
Low backlighting
Steam accumulation on the door, hot air
output from the ventilation openings.
The microwave oven has been switched on
without food inside.
Troubleshooting
Malfunction
The unit does not switch on
No heating
Noise from the rotating glass tray
during operation
DELIVERY SET
Oven – 1 pc.
Glass rotary bottom plate – 1 pc.
Roller ring – 1 pc.
•
•
•
•
•
•
•
•
During operation of the unit, interference in the reception of TV and radio signals
can appear. Similar interference appears during operation of small electrical
appliances such as a mixer, a vacuum cleaner and a hairdryer. It is normal.
Oven cavity lighting can be low when low microwave power level is selected. It is
normal.
During cooking, steam can evaporate from the products. Most of the steam comes
out through the ventilation openings, but some part of it can accumulate on the
inner side of the door. It is normal.
Switching on the unit for several minutes without food does not cause its damage.
Always make sure that there is food in the unit before switching it on
Possible cause
The power cord plug is not properly
inserted in the socket.
Malfunction of the electric socket
The door is not closed tightly
The lower part of the oven cavity or the
roller support is dirty
Roller support – 1 pc.
Grill grate – 1 pc.
Instruction manual with warranty certificate – 1 pc.
30
Do not use ammonia detergents.
Use a damp cloth to clean external surfaces.
Always keep the door clean.
Provide that no crumbs and food remnants accumulate
between the door and the front panel of the oven as it
prevents the door from normal closing.
Regularly clean the ventilation openings on the oven
body from dust and dirt, as air for cooling the unit pass-
es through them.
Regularly take out and clean the glass rotary bottom
plate and the roller support, wipe the bottom of the
oven cavity.
Wash the glass rotary bottom plate and the roller ring in
water with a neutral soap solution. You can wash these
parts in a dishwashing machine.
Do not immerse the heated glass rotary bottom plate
into cold water: the glass plate can splinter due to ex-
treme temperature difference.
Solution
Pull the plug out of the socket. After 10 seconds
insert the plug into the socket again
Try to connect another unit to the same socket
Close the door tightly
Wash the glass bottom plate, the roller support
and the bottom of the oven cavity