ENGLISH
– Connect the microwave oven to a socket with reliable
grounding contact.
– Set the unit on a flat and hard surface that will bear its
weight and maximum weight of the products, which will
be cooked in it.
– Do not install the unit in places with high moisture and
temperature and near inflammable objects.
– Choose the place that is out of the reach of small chil-
dren.
– Place the microwave oven keeping at least a 20 cm gap
from the sides and the rear of the oven to the wall and a
30 cm gap above the unit.
– Do not remove the supporting legs from the bottom of
the oven.
– Do not block the ventilation openings in the microwave
oven body.
– Place the microwave oven away from the TV-set or radio
to avoid interferences in the reception of TV and radio
signals.
WARNING: In case of user-caused oven failure, the user
shall be deprived of free maintenance and repair of the
unit.
MICROWAVE OVEN OPERATION
Sound signal
Every pressing of the control panel buttons (7) is confirmed
by a sound signal.
Current time setting
The «Clock/Defrost» button (11) allows to set the current
time or preset the start time of the cooking program.
If necessary, you can skip this setting and use the oven
without it.
1. Insert the power cord plug into the socket, all the sym-
bols (17-28) will light up three times on the display (9),
then you will hear a sound signal, and time «1:00» will
appear on the display (9). You can set the desired time
in the range from «0:00» to «23:59».
2. Press and hold the «Clock/Defrost» button (11) for more
than 3 seconds, the clock indicator digits (28) will be
flashing.
3. Turn the knob (13) to set the hour on the display in the
range from 0 to 23.
4. Press the «Clock/Defrost» button (11) once more to con-
firm, minute setting digits (27) will be flashing.
5. Set the minutes value in the range from 0 to 59 by turn-
ing the knob (13).
6. Press the «Clock/Defrost» button (11) to confirm, sym-
bols «:» will be flashing.
Example: setting of 12:30
Steps
1
After switching on, the «:» symbol flashes
2
Press and hold the «Clock/Defrost»
button (11) for 3 seconds.
3
Set the exact time in hours by turning the
«Time/Weight» knob (13)
4
Press the «Clock/Defrost» button (11)
once more
5
Set the exact time in minutes by turning
the «Time/Weight» knob (13)
6
Press the «Clock/Defrost» button (11)
once more or wait for 60 seconds to
switch over to the indication of the preset
time on the display (9)
Notes:
• If the clock is not set, the current time will not be shown.
• If no actions during current time setting are taken within
1 minute, the unit will be switched to the previous mode.
• If you press the «Pause/Stop» button (14) while setting
the time, the unit will be switched to the previous set-
tings.
«Time/Weight» setting knob (13)
The regulator knob is intended for setting and correcting
the parameters of cooking programs, as well as setting
the time.
«Pause/Stop» button (14)
The «Pause/Stop» button (14) can suspend cooking at any
step, cancel an incorrect command or cooking mode when
pressed once, stop cooking completely when pressed
twice, and lock/unlock the control panel (9) buttons when
held for a long time.
COOKING IN THE MICROWAVE OVEN
Before cooking food set the power level of the microwave
oven and the cooking time or select a auto-cooking pro-
gram.
Microwave cooking mode power button
1. Open the oven door by pulling the handle (8) and put the
food into the oven cavity.
2. Press the «Power» button (10), the display (9) will indi-
cate symbols «MW» (17), power level 100P by indicators
24
Indication on
the display
1:00
1:00
12:00
12:00
12:30