16. Record function: In USB/TF mode, press "REC" button to record
INSTALLING THE BATTERIES IN THE REMOTE CONTROL
Remove the battery cover from the back of the remote control as shown
and insert 2x AAA size batteries ensuring correct polarity
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed.Only replace by the same or equivalent type.
WARNING : Do not swallow the battery. Danger of chemical burns. Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body, contact imme-
diately a doctor.
MODE BUTTON
Press the button 10 on the unit or 2 on the remote control and select BLUETOOTH (BLUE is displayed), USD/mi-
croSD (only if the USB or TF inputs are connected) or AUX (AUX is displayed).
VOLUME ADJUSTMENT
Turn the volume control (13) on the unit, or press the button (11) on the remote control to adjust the overall
volume
BASS / TREBLE ADJUSTMENT
Press the VOLUME wheel (13), then press once to select Treble, press twice to select Bass. Rotate the main vol-
ume control (13) to adjust the setting to the desired level.
MIC VOLUME ADJUSTMENT
Turn the MIC volume control (14) on the unit until the desired parameter is displayed. Then, rotate the MIC
VOLUME control to increase or decrease the value. The MIC VOLUME wheel allows to adjust the mic volume, mic
echo, mic bass, mic treble and of the volume of the connected guitar.
Note: the echo effect only works on the microphone input.
GUITAR VOLUME
Press the MIC VOLUME button (14) on the unit UNTIL GT VOL is displayed and rotate the wheel to adjust the
guitar volume.
Note: This function is only available when a guitar is connected
PRE-EQUALIZER
The system has a preset audio equalization system. Press the EQ button (15) on the remote control repeatedly
to select one of the 5 audio equalizations available and which best suits the current music.
LED LIGHT SWITCH
Press the light button (11) on the unit or (17) on the remote to cycle through the various light effects and switch
the light off.
BLUETOOTH FUNCTION
Press MODE button on the unit or the remote control until BLUE is displayed and flashing.
1. Put the cell phone within 1 meter
2. Activate the BT search function on your cell phone to search for the BT device. Please refer to the user
manual for details
3. Select COLUMBA1200 in the list of found devices.
4. Shortly press the PLAY/PAUSE button ▶ to play or pause the music. Shortly press the " " or "" button
to select the previous or next track.
AUX MODE:
Press the MODE button on the unit or the remote control until AUX is selected. Play the music of the device
connected to the AUX input via a 3.5mm Jack.
USB / MICRO-SD MODE:
1. Insert a USB or TF device and press the MODE button to select "USB" or "TF" mode. The unit will automati-
cally read and play the music in the connected device.
2. Press "▶" button shortly to pause or play.
Code: 17-2044
http://ibizashop.eu/
5