Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING MANUAL
Installation:
The AmbientArt LED end section is directly connected to the AmbienTrack cover using the adhesive pad:
1.
Place the flat side of the AmbienTrack cover on a flat, clean surface.
2.
If necessary, use a suitable cleaning agent to clean the part of the cover between the two struts where you
wish to position the end section.
3.
Take the protective film off the adhesive pad.
4.
Place the LED end section onto the upper edge of the AmbienTrack cover at an angle of approx. 45°, and centre
it.
5.
Now place the LED end section in the right angle so that the adhesive pad is positioned between the two struts
on the cover. Make sure that there is no gap between the cover and the LED end section.
6.
Attach the adhesive pad by firmly pressing the sides of the protruding tabs of the LED end section housing.
7.
You can adjust the position of the end section by loosening the two nuts slightly and placing the end section in
its final position. Then tighten the nuts relatively firmly.
10
Werbung
