Brinno TLC200 Pro Bedienungsanleitung Seite 9

Timer
The Timer will allow you to pre-set a recording period.( eg. 8 am —5 pm )
1. Set the start recording time , then set the stop recording time. The time
is set in 15 minutes increments. Press MENU to lower the number, press
TIME to increase the number and press 0K to next column. Or you may
select Cancel to disable Timer setting. 2. After setting up the time, go back
to the set up screen then press the 0K button to move to the preview
screen. Hold the 0K button for 2 seconds to start recording. The LCDpanel
will show RECthen turn off to save power. The camera will automatically
activate at the start recording time you selected.
A ONCE YOU ACTIVAT
WORK ATTHE
Exposure
Into Exposure setting, pressMENU ( 49 and TIME(
( + ) or decrease ( - ) the exposure and press 0K to exit.
Custom
Control Saturation,
setting, using MENU ( + ) and TIME (
press 0K to exit.
Time
You can choose if you want the time stamp to show at bottom of
your video. 1. Select Time Stamp. 2. Select ON or OFF.
Low Light
You can choose to set up your camera to record videos in a low light
environment
Allows your Camera to record video in a low light environment.
Your camera will go to sleep in a low lightenvironment.
Set Date
Set the Correct date and time for your camera.
& Time. 2. In the highlight field, press MENU ( - ) to decrease the
number, pressTIME( 4) to increasethe number, press0K to confirm
and go to the next field. When finished, press 0K to exit set up.
LED Indicator
You can choose
capturing each frame.
camera is capturing a frame, the LED indicator will flash once. OFF:
During capture period the LED indicator will not flash at all.
Band
Select the correct fluorescent
indoor lighting
outdoor environment.
08 ENGLISH
E TIMER, YOUR TIME LAPSE CAMERA WILL ONLY
TIMER SETTING
Image
Contrast,
More
Stamp
Recording
or not. (< 5 Lux). 1. Select Low Light Recording. 2. ON:
& Time
whether or not the LED indicator
1. Select LED Display. 2. ON: When the
Filter
frequency.
50 Hz: USA 60 Hz: Europe
PERIOD.
Sharpness. Select and enter
) to adjust the effect. Then
Settings
lighting frequency
1. Select Band Filter. 2. None: For
to increase
each
OFF:
1. Select Set Date
will flash while
to match your