Connecting To The Internet; C) Execution Of Firmware Updates - Renkforce renkCast Musik Bedienungsanleitung

b) Connecting to the Internet
• It is possible that the WLAN setup will start automatically the first time you start the
App and tap the button with the magnifying glass. If this is not the case, tap the button
"AirSetup" at the lower middle of the main menu first, and then "Internet" on the next
page.
• Select your WLAN network and enter the password and confirm with "OK".
When the connection has been successfully established, the selected WLAN ap-
pears with a blue background. The white LED at the front also flashes slightly blue.
Apart from this, it does not matter if your tablet is connected to the box's
WLAN or your present WLAN.
• Tap the blue EZCast button to return to the main menu.

c) Execution of Firmware Updates

After you have connected the box to the internet, you should check whether a new
version of the firmware is available. Proceed as follows:
• Tap the button "AirSetup" in the lower middle of the main menu again.
• Scroll all the way down. If a new version is displayed at the lowest item on the right,
tap it.
• Wait for a few seconds until the firmware version of the box and the current version
online are displayed.
• Tap update to install the update. It is then downloaded and installed. During the up-
date, the LED will alternatingly flash white and blue.
During installation, the music box must not be disconnected from the voltage
supply, since the product may be damaged otherwise.
• When the LED is lit white again and additionally flashing slightly blue, restart has
been completed.
26