Lippert R-SKIRUN Installations- Und Gebrauchsanleitung Seite 13

USE AND GUIDANCE
• Be careful when opening the rear doors; to consider the dimensions given by the accessory and
the transported load.
• As a result of the installation of load bearing and load devices moderate driving under
acceleration, braking and cornering. In particular the effect wind, sudden braking, closed curves,
bumps and holes modify the driveability of the vehicle.
• Respect the speed limits and the highway code. Speed must always be adapted to the conditions
of the road surface, traffic, weather conditions and the load being transported.
• Tackle slow motion bumps at no more than 15 km/h (9 mp/h).
• Be careful before washing the vehicle with automatic systems; if necessary, remove the
accessory.
MAINTENANCE AND CONSERVATION
• Belts, bolts, etc., and wearing parts, may over time be damaged and must be replaced. Lubricate
regularly adjustment screws and bolts to extend the life of the accessory.
• In case of accidental fall of the accessory, check immediately that there are no damages such as
cracks or conspicuous dents as to affect the correct functioning of the accessory. Substitute, in
this case, the damaged part or the accessory itself.
• The product must be regularly cleaned with hot water and a neutral pH soap, then dry with a
cloth. Avoid contact with aggressive chemical agents (eg solvents).
• Avoid falls
RESPONSIBILITY
• In the case of transport on your own vehicle, you are fully responsible of yours and the safety of
others. The manufacturer assumes none liability for any damage to property or persons caused
by incorrect assembly of the accessory, as well as excessive speed or from driving not respectful
of atmospheric conditions, traffic and road surface. Make any warnings aware of these warnings
another driver uses your car with the accessory installed. The manufacturer is not liable in the
event of damage to things or people during installation of the accessory.
DISPOSAL
• It is recommended to dispose of the product and packaging in an ecological way, separating the
different materials for the recycling, as required and as required by local laws.
• Preferably dispose of this item through a company waste disposal; ask your local competent office
in case further information is needed in this regard.
• Be sure to comply with all regulations currently in force in your country.
13 CCD-0007172