Werbung
pressing the power button once. Brush your teeth without putting excessive
pressure on the tooth enamel. Every 30 seconds, the device will notify you to
change the brushing zone by briefly stopping the vibration. Change the
brushing zone after each notification. After 2 minutes of operation, the device
will turn off automatically.
Cleaning and Maintenance
ATTENTION! Turn off the device and disconnect the charging station from the
power source before cleaning the device and accessories.
ATTENTION! Do not wash the device or its accessories in a dishwasher.
ATTENTION! Do not use chemical and aggressive detergents, abrasive pastes,
products containing acids and solvents or steel wool scrubbers to clean the
device and accessories.
Cleaning the Brush Head. Rinse the brush head, including the bristles, under
running water.
Cleaning the Handle. Rinse the handle under running water or wipe with a
soft cloth dampened with water. Then wipe dry.
Cleaning the charging station. Wipe with a soft cloth dampened with water.
Then wipe dry.
Troubleshooting
The toothbrush does not turn on. Possible cause: the battery is discharged.
Solution: charge the device (charging time – up to 4.5 hours).
The toothbrush is not charging. Possible causes: the charging station is not
connected to a power source; the USB cable is damaged. Solution: connect the
charging station to a power source (see Fig. B); check the integrity of the USB
cable.
Weak vibration of the brush head. Possible cause: the place where the handle
and the brush head connect is dirty. Solution: clean the handle and the brush head.
ATTENTION! If none of the suggested solutions helped you eliminate the
problem, contact the supplier or an authorized service center. Do not
disassemble the device or attempt to repair it yourself.
10
aeno.com/documents
Werbung
