Werbung
Action
Press once (it has been less than 8 seconds since
the device was turned on)
Press once (it has been more than 8 seconds
since the device was turned on)
Operating Modes
"Clean" for daily brushing of the teeth;
"White" for teeth whitening;
"Sensitive" for brushing sensitive teeth;
"Massage" for a thorough gum massage;
"Gum Care" for a gentle gum massage.
Preparing the Device for Use
Charging. Carefully open the package and take out the device and its
accessories. Clean them (see "Cleaning and Maintenance"). Place the charging
station (7) on a dry, horizontal surface. Connect the station to a power supply
(see Fig. B). Place the handle (2) on the charging station. The indicator (5) will
start to flicker red. When the indicator turns green, the battery is fully charged
and the device is ready for use. When charging is complete, disconnect the
charging station from the power source.
Installing the Brush Head. Remove the handle from the charging station and
install the brush head (1) as shown in Figure C.
Choosing the Operating Mode. Press the button (3) to turn on the device.
Continue to press the button to switch the operating modes. You can change
the mode within 8 seconds after turning the device on. Then press the button
again to turn off the device.
Note. The last selected operating mode is stored in the device memory and will
be activated the next time the device is turned on.
Operation
Wet the bristles of the brush head and apply the desired amount of a dental
care product to the bristles. Point the bristles of the brush head toward the
tooth surface at an angle of about 45° (see Fig. D). Turn on the device by
aeno.com/documents
Description
Switch operating modes
Turn off the device
9
Werbung
