MALTEC MasterMeter Bedienungsanleitung Seite 19

Continuous Measurement
Long press to activate Continuous measurement , sweeping slowly
the laser back and forth and up and down over the desired target point from a fixed
measuring point, then press to stop, the value for Maximum and Minimum
distances are displayed in the screen as well as the last measured value marked in the
summary line. You can choose Max or Min value according to your needs.
Area Measurement
Press to select Area measurement mode . According to reminding of the
flashing line, press to get the distance for 1 st line (Length), press
again for 2 nd line (Width), the Area is calculated and displayed in the summary line.
19/ 38