cecotec CONGA GRASSHOPPER 800 CONNECTED Bedienungsanleitung Seite 127

Changing the mower's time and programming the operating range
- The mower's time must be set by pressing and holding the
mower to follow the programming correctly.
- The default operating range is from 9:00 to 15:00, but you can change it. To do so, press and
hold the and
mower to start operating at 13:25, when
select the desired time, press the
the display, and the mower will automatically start operating at 13:25. You will hear a beep
when you do so. Fig. 12
Changing the mower's operating time per day
- The default daily operating time is 3 hours, but you can change it (the minimum time is 1
hour, and the maximum is 24 hours).
- To do this, hold down the
time to be 06 hours, press the
flashes, press
mower will run for 6 hours a day from the start time you have set. You will hear a beep
when it starts up. Fig. 13
Changing the days of operation per week
- By default, the mower will operate 5 days a week. You can change this setting to 3, 5 or 7
days. For example, imagine you want to select 3 days per week.
- The number "05" will flash. Press the
and then press
3 = Monday, Wednesday, and Friday.
5 = Monday, Tuesday, Wednesday, Thursday, and Friday.
7 = Monday, Tuesday, Wednesday, Thursday, Friday, Saturday, and Sunday.
By default, the mower will cut the edges skirting the boundary wire on Tuesdays and Fridays.
Remember that if you have the mower configured with 3 cutting days, Tuesday will not perform
edge cutting because it has not programmed that day in its operating range.
Rain sensor configuration
- The mower has a built-in rain detection sensor. It will stop operation by default and return
to its charging station until it stops raining and a preset stipulated time has elapsed.
- To access this menu and activate/deactivate this function, press, and hold the
for 3 seconds.
select the option ON or OFF on the display by pressing
confirm your selection.
buttons at the same time for 3 seconds. For instance, if you want the
button to confirm the setting.
button for 3 seconds. For example, if you want the operating
or
to confirm the setting.
to confirm the setting. The following will appear on the display:
will appear on the display. Press
flashes, use the
buttons to select the number (06) and, when
will appear on the display. The
or button to select the desired number (03)
and
CONGA GRASSHOPPER 500 CONNECTED
ENGLISH
button for 5 seconds for the
or buttons to
will appear on
to access the settings and
, and then press
button
to
127