RONDELL RDE-1457 Betriebsanweisung Seite 13

TROUBLESHOOTING
Malfunction
The motor does not start and/ The unit is not connected
or the screw does not rotate to the mains
The motor stops during The unit is overloaded.
operation Protection has switched
on
The screw stopped rotating The unit is overloaded with
but the motor does not food products
switch off
The crossed blade is not
installed correctly
The unit vibrates during The food products are cut
operation into very large pieces
STORAGE
•
Before taking the meat grinder away for storage, make sure that
the meat grinder body and all removable parts are clean and dry.
•
Store unused attachments (15, 16, 17) inside the inner com-
partment under the pusher lid (7) (fig. 11).
•
Keep the unit in a dry cool place out of reach of children and
disabled persons.
DELIVERY SET
Meat grinder – 1 pc.
Pusher – 1 pc.
Food tray – 1 pc.
Plates – 3 pcs.
Set of sausage filling attachments – 1 pc.
«Kebbe» attachments set – 1 pc.
Instruction manual with warranty certificate – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220-240 V ~ 50 Hz
Rated input power: 450 W
Maximum power: 2200 W
The manufacturer preserves the right to change design, struc-
ture and specifications not affecting general principles of the
unit operation without a preliminary notification due to which
insignificant differences between the manual and product may
be observed. If the user reveals such differences, please report
them via e-mail info@rondell.ru for receipt of an updated manual.
Possible cause
Plug the unit
Switch the unit off. Unplug the unit from the mains. Let the unit cool
down for approximately 1 hour and 15 minutes. Insert the plug into
the socket. Switch the unit on again. If the meat grinder cannot be
switched on, it may mean that it is damaged. In this case apply to an
authorized service center to repair the meat grinder
Switch the unit off. Then, no later than after 30 seconds, press and
hold the switch button «REV» (reverse). The screw will start rotating in
the opposite direction and the screw block will be unloaded. Let the
meat grinder operate in this mode for several seconds and then switch
the reverse mode off. Switch the unit on in normal mode.
If the application of the «Reverse» mode did not work, unplug the unit
from the mains and clean it.
Install the crossed blade with the cutting side facing the cutting plate.
Cut the products into smaller pieces
RECYCLING
For environment protection do not throw out the unit and the bat-
teries (if included), do not discard the unit and the batteries with
usual household waste after the service life expiration; apply to
specialized centers for further recycling.
The waste generated during the disposal of the unit is subject
to mandatory collection and consequent disposal in the pre-
scribed manner.
For further information about recycling of this product apply to a
local municipal administration, a disposal service or to the shop
where you purchased this product.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale
or receipt must be produced when making any claim under the
terms of this guarantee.
13
Solution methods
This product conforms to the EMC Directive
2014/30/EU and to the Low Voltage Directive
2014/35/EU.
ENGLISH