Effects Loop; Input - Tines & Reeds Rhodestar Bedienungsanleitung

Jack for connecting a footswitch to toggle the tremolo on or off.

EFFECTS LOOP

RETURN R:
Jack for connecting the effect return, right channel. If this jack is left unused, the signal for the
right channel will be taken from the left.
RETURN L:
Jack for connecting the effect return, left channel. If this jack is left unused, the SEND jack
can be used as an additional output to tap into the audio signal before the tremolo and DSP,
for example to connect the dry signal to a guitar amplifier or audio interface.
SEND:
Jack for connecting additional effects. The SEND is positioned in the circuit after the equalizer
and before the tremolo & DSP, as shown in the flowchart at the end of this manual. This allows
for integrating external stereo effects as well.

INPUT

GAIN:
Control for setting the level of the preamplifier. The more the GAIN control is turned up, the
sooner the compressor will engage. For optimal noise performance, a higher setting is
recommended.
INPUT:
Jack for connecting the instrument.
19