Effect - Tines & Reeds Rhodestar Bedienungsanleitung

EFFECT

ON/OFF:
Switch for turning the effects section on and off.
NOTE: This switch only interrupts the audio path to the DSP. The DSP itself remains active. This
allows for experimentation for example, a delay can be set up to run in a loop. If you switch
the DSP to OFF, the delay continues running and you can play over it. The MIX control
even allows you to fade out and later fade in this loop. Have fun experimenting!
PARAM. 1 / PARAM. 2 / PARAM. 3:
Controls for adjusting the effect parameters.
PROGRAM:
Rotary switch for selecting the effect program.
Typ
1. Shimmer Reverb
2. Plate Reverb
3. Stereo Delay
4. Mono Delay
5. Chorus
6. Phaser
7. Flanger
8. AutoWah
MIX:
With this control the signal from the DSP can be mixed with the dry Rhodes signal. When
turned fully clockwise, the dry signal is no longer audible.
PARAM. 1
Shimmer Level
Pre-Delay
Time
Time
Time
Rate
Rate
Sensitivity
PARAM. 2
Reverb Time
Size
Feedback
Feedback
Feedback
Depth
Depth
Filter Freq.
PARAM. 3
Damping
Damping
Reverb
Reverb
Reverb
Reverb
Reverb
Reverb
16