Antari M-5 Bedienungsanleitung Seite 7

Adjust the duration of each fog emission
means of the Up/Down buttons. Under the menus 'Timer Out' and 'Volume Outn you
can adjust the output volume by means of the Up/Down buttons. The menu 'DMXAddR
refers to adjusting
desired DMX-address
2. Press the Timer button to activate the timer function.
Interval and the devlce counts the seconds down to •or. After that, the fog em18810n 18
triggered at the volume adjusted under •Tlmer Out". The duratlon depends on the
settings adjusted
pregg the Timer button once more.
3. Press the VOIume switch for immediate triggering Ofthe fog emission at the volume
adJu8ted under •vol ume Out'. Press the Volume swltch once more In order to stop the
fog emission.
4. Press the Manual button for Immediate trlggerlng
Let the Manual button loose in order to stop the fog emission.
Z-30: All Z-20 features
dlgtance of 50 meters.
dlfferent unlts can be controlled
Function to cycle to RF mode to select desired address number. Make sure the
address setting on the Z-30 matches the address setting on the transmitter.
two buttons an the transmltter.
operation.
z-20
5-pin XL
Cable Length: 10 m
Connector: 5•pin XLR
Function: Timer with Interval,
and Volume: set DMX Address;
Continuous Fogging; Manual OFF
Performance
'All fog machlnes develop condensatlon around the output nozzle. Because thls may
result in some moisture accumulation
this condensation
•All fog mechlnes may 8putter small amounts of fog occasionally
e minute or so after being tumed off.
'All fog machines have a recycling
itself down for a short period in order to heat up again. During this time no fog can be
produced.
Malntenance
Do not allow the fog llquld to become contamlnated. Always replace the caps on the fog
I iquid container and the fog machine liquid tenk immediately
hours of continuous
the DMX address for DMX control or synchronization.
by means Of the Up/Down buttons.
under "Duration SetR. If you wish to deactivate
plus wireless capability.
The address
separately
The blue one 18to emlt fog and red one 18to stop the
LCD-Display
Function Buttons
duration
Note
when installing your unit.
perlod after long bursts when the machine will shut
operation, it is recommended
(within the range of I to 20 seconds)
The display shows the adjusted
ofthe fog em18810n et 100 % volume.
Wireless operation
can be get from O to 81 whlch
or In any comblnatlon
Z-30 (Wireless)
Antenna
Blue(emit) Red(stop)
Transmitter
5-pin XLR
on the surface below the output nozzle, consider
to run a cleaning solution composed
6
by
Adjust the
the timer function,
is possible up to a
means a max. 9
deslred. Press
There are
Cable Length: 2 m
Wireless Range: up to 50 m
Connector: 5-pin XLR
R.F. Address:
LCD-Disptay
Function Buttons
durl ng operatlon
after filling. After every 40
end for