max2h EVOLIFT BMW R 1200 R Montageanleitung Seite 8

Mounting the adapter plate Montage Adapterplatte
3. Pre-assemble the adapter plate:
1. Screw the upper pin [2] to the adapter plate [1].
2 Insert the locking screw [5] through the slotted hole
and lock it with the lower pin [4] on the back, but do
not tighten it yet.
4. Fixing the adapter plate:
1. Attach the adapter plate to the motorcycle with the
upper pin [2] and align the lower pin [4].
2. Tighten the lower pin [4] with the Locking screw [5].
5. Refit the rollers on the central stand:
To lift the motorcycle optimally, the rollers must be
bolted to the bottom of the crossbars.
Please note: One crossbar only has one hole for the
screw connection at the bottom. This does not present
any further problems.
6. Screw the adapter plate to the center stand:
1. Mount the tilt adjustment (pre-assembled on the
central stand) on the adapter plate. To do this, loosen
both nuts [M1] and the nut on the rear [M2].
2. Screw the adapter plate to the base plate.
(Do not tighten the screws so that the adapter plate
can move freely)
1
2
2
5
M2
M1
4
5
4