Installation; Display Device Setup - Inverto IDL-5000HD Handbuch

1EnIDL5000HD-print.fh10 1/18/06 12:53 PM Page 9

4.3 Installation

The on-screen display will ask which type of display device is
being used. You will have a choice of either Plasma / LCD (Flat
panel displays) or CRT (eg Standard television).
Select from the choices using the remote control keypad.
Note: Not all video formats are available in all modes. The following
table describes the available formats in each mode.
LCD/Plasma
576i
576p
1080i
1152i
720p
Table 1: Output format table
When all formats have been tested, a list of all accepted video formats will be displayed. You can select
the format you preferred from the list.
The accepted display formats are then displayed and you are requested to select your preferred
display format, the selected output format can be changed at any stage in the User Preferences menu.
Anytime you change the rear panel switch or change display device, you will have to restart the
procedure again.
If you choose an output format, which is nt supported by the display, you can recover by changing the
rear panel switch.

4.4 Display Device Setup

The on-screen display will ask which type of display device is
being used. You will have a choice of either Plasma / LCD (Flat
panel displays) or CRT (eg Standard television).
Composite
HD (YPbPr)
CRT
X X
X X
X X
X
X
C M Y CM
HD (RGB)
LCD/Plasma CRT
X X
X X
X
X
MY CY CMY K
SD (CVBS)
LCD/Plasma CRT
X X