Replacement Of Battery - PeakTech 2860 Bedienungsanleitung

5.6. Over Range Indicator
The display will show the over range indicator "- - - oL - - - " along with the
"BIBI..." sound, if
* Input signal frequency over 10 MHz for 10 MHz range.
* Input signal frequency over 100 MHz for 100 MHz range.
* Input "0 Hz" for the period range.

6. Replacement of battery

1. If the meter used the battery power source, when the display values flashed,
it is necessary to replace the batteries. 3-23 Battery Cover Screws/Battery
Compartment.
2. Loose the Battery Cover Screws (3-23, Fig. 1), take the battery cover away
from the instrument and remove the batteries. Replace with 6 x 1,5 V AA
(UM-3) batteries and reinstate the cover.
3. Make sure the battery cover is secured with the screws after changing
battery
Statutory Notification about the Battery Regulations
The delivery of many devices includes batteries, which for example serve to
operate the remote control. There also could be batteries or accumulators built
into the device itself. In connection with the sale of these batteries or
accumulators, we are obliged under the Battery Regulations to notify our
customers of the following:
Please dispose of old batteries at a council collection point or return them to a
local shop at no cost. The disposal in domestic refuse is strictly forbidden
according to the Battery Regulations. You can return used batteries obtained
from us at no charge at the address on the last side in this manual or by posting
with sufficient stamps.
-22-