SwitchBot Curtain 3 Rod Benutzerhandbuch Seite 16

4. Adjust your SwitchBot Curtain 3 Rod to keep it perpendicular to the ground.
Step 3: Install Magnet Attachment
The magnet attachment will help your SwitchBot Curtain 3 Rod run precisely to close your
curtains in future operation. Follow the steps below to install the magnet attachment
before route calibration.
To ensure the magnet attachment firmly attaches to your track surface, please use the
wet wipe provided to clean the surface first. Dirst or dust will affect adhesion and may
cause dropping at a later time.
Situation 1: A rod bracket is holding the rod at the closed position.
1. Remove the magnet attachment from the liner. Stick it to the bottom of the road
along the bracket, with the magnet piece inside parallel with the rod.
If you use double-sided curtains, stick two magnet attachments along both sides of
the middle bracket symmetrically.
16