Texas Equipment RMX 500 Bedienungsanleitung Seite 85

Display
E7 Tilt sensor has
been triggered
Slope may be too
steep
E8 Return to charging
station failed
BP Battery
temperature
is too high or low
EE Error unknown
- Increased noise
Poor cutting result
- The robot runs in
circles around itself
If the robot has run out of power and cannot be started, manually lift it back into the
charging station and charge it before attempting troubleshooting. For other error codes,
turn off robot and restart. If none of these solutions solve the issue, contact TEXAS.
Regardless of the problem that occurs, it is always recommended to first try to restart the
robot and see if that fixes the problem. Turn off the robot, wait 10 seconds and turn it back
on
For further assistance and troubleshooting, contact Texas by phone: +45 6395 5555.
Notice
If the slope of the lawn is higher than 20
robot stop. The area should be removed from the cutting area.
1. Turn off the robot and carry it to a flat area without
obstacles.
2. Turn on the robot, enter password, press START and then
on OK.
1. Check that the boundary wire in front of the charging
station is straight for 1 m without corners or obstacles to
ensure correct connection.
2. The charging station must be placed on a completely flat
and solid surface. It must not be placed on a sloping
surface.
3. Avoid that there are more than 2 meters of coiled cable
nearby to the charging station, as this may interfere with
the signal. If necessary, move excess cable and shorten it.
4. Be sure to remove/cut grass that grows up around the
charging station
5. Manually lift the robot into the charging station for
charging. When the robot is fully charged, turn it on, press
START, and then OK.
1. Check if battery is very hot. If necessary, put the robot in
shadow. Wait until the battery is cooled off and restart.
A garage/roof protects the robot from weather conditions.
2. Check if the battery's temperature is too low (do not leave
the robot outdoor if the temperature drops below 0
degrees).
Wait until the battery is in an environment that are above 5
degrees and restart.
3. If that doesn't fix the problem, the battery is probably
damaged and needs to be replaced.
1. The upper cover may not be mounted correctly.
Press it firmly down on the machine (onto the 4 sensor
sticks)
2. Restart the robot. Turn off the robot and wait 10 seconds.
3. Turn the robot back on, enter PIN code, press START and
then on OK. If the error code still appears, contact Texas
1. The blades are wrapped with grass and cannot rotate
freely.
Unscrew blades, remove grass and reattach.
2. Restart the robot. Turn off the robot and wait 10 seconds.
3. Turn the robot back on, enter password, press START and
then on OK. If the error code still appears, contact Texas
1. Check if one of the wheels can turn without resistance.
If so, the pipe split in that wheel may have broken and
need to be changed. Contact Texas.
Solution
85
o
, it can make the