Real Time Clock - Rivacold Riv-Evo Bedienungsanleitung

Screen
NOTE - If no keys are pressed for 300 seconds (5 min), the control automatically returns to the standard
NOTE - When changing parameters, the newly set value is stored every time the SET key is pressed.
3.2.3

"Real Time Clock"

The electronic board's internal clock must be updated by accessing the "RTC" parameter in the "STG" group.Follow
the steps below, after entering the password.
Screen
Instruction manual | v. 02 | 9600-0075 | © 2022 RIVACOLD srl
BEST R290
Description
Press SET and UP for 3 seconds
PSS appears on the display, indicating the password
must be entered. Press SET to enter
P 0
password using the UP/DOWN keys
P 0 appears again; repeat the operation until all 4 digits
in the password are entered
When the password has been entered, the display
Press UP/DOWN to select the desired category
Description
parameters menu...
Press UP/DOWN to select the "STG" category
SET
When RTC is displayed, press SET
The display shows tZ alternated with a number
indicating the set time zone. To skip the setting and
move on, press DOWN
To set a new time zone, press SET.
See the time zones summary table in the appendix to
select your zone
SET.
Key to press
EN
Key to press
17