Installation; Installation Warnings; Isolation From Energy Sources; Check Supply - Rivacold Riv-Evo Bedienungsanleitung

Safety

2. Installation

2.1 Installation Warnings

2.1.1

Isolation from energy sources

ATTENTION!
• Before carrying out maintenance work, disconnect the power supply to the unit.
2.2 Installation
2.2.1

Check supply

When the product is received, check the goods are intact. If any faults or defects are found, do not install the prod-
uct. Please contact RIVACOLD S.r.l. immediately.
The supply includes:
EN
RIV-EVO Controller board
1
5 plastic spacers
2
instructions.
3
2.2.2

Replacement of components

If in doubt, always contact RIVACOLD S.r.l. before carrying out any intervention.
DANGER! - Before making any electrical connection it is essential to disconnect the power supply.
To replace the board:
remove the protective panels and access the internal parts of the appliance by following the procedure de-
1
scribed in the instruction manual of the unit in paragraph "REMOVING THE FRONT PANEL" for BEST Wx
models, or in paragraph "REMOVE THE SIDE PANELS" for BEST CM models
identify the board inside the appliance
2
disconnect it from the electrical connections while referring to the wiring diagrams and the instruction man-
3
ual in paragraph "CONNECTING THE MONOBLOC TO THE MAINS"
remove the board from its seat
4
position the new board and fasten it in the same way as the previous one
5
connect the electrical connections while referring to the wiring diagrams and the instruction manual
6
reposition any guards/panels/components previously removed.
7
WARNING! - Before restarting the appliance, check the earthing and that the wiring is not damaged. Replace
any damaged cables.
12
BEST R290
Instruction manual | v. 02 | 9600-0075 | © 2022 RIVACOLD srl