Access To Modify Parameters; User Types; Accessing The Parameters Menu - Rivacold Riv-Evo Bedienungsanleitung

Screen
EN

3.2 Access to modify parameters

3.2.1

User types

Below are the types of users and priorities with their access password:
• INSTALLER (password: 2311)
• END-USER (password: 2201).
3.2.2

Accessing the parameters menu

Follow the steps below to access the parameters menu.
Screen
14
BEST R290
Description
Press UP/DOWN to select the desired value:
1
BEST Medium Temperature with 1 Compressor
2
BEST Low Temperature with 1 Compressor
3
BEST Medium Temperature with 2 Compressors
4
BEST Low Temperature with 2 Compressors
without touching any keys (approximately 1:30 min)
Once the parameters are saved, the display shows
message "dOn". Press SET to continue
Select YES to conclude the initial switch-on procedure
SET
At the end of the procedure, the controller uploads the
software based on the selected Model Unit. Do not
touch any keys during this phase
Once the upload is complete, the controller displays
signal rEb and then reboots a few seconds later. Do
not touch any keys during this phase
Description
Standard display (example image)
SET
Instruction manual | v. 02 | 9600-0075 | © 2022 RIVACOLD srl
Key to press
Key to press