Trouble Shooting; Technical Data; Noise - Powerplus Powdp7070 Bersetzung Der Originalbetriebsanleitung

11 TROUBLE SHOOTING

Problem
The compressor does not
start.
The compressor starts but
there is no pressure.
The compressor
pressure is shown on the
pressure gauge, but the
tools do not start.

12 TECHNICAL DATA

Type
Rated voltage
Rotation speed
Rated Pressure
Tank capacity
Air debit (capacity)
Weight

13 NOISE

Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
Acoustic power level LwA
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
Copyright © 2020 VARO
1. No power supply.
2. outside temperature is too
low.
3. Motor is overheated.
1. The
leaks.
2. The seals are damaged.
3. The drainage cock for
condensation water has a
leak.
starts, 1. The hose connections
have a leak.
2. A quick-lock coupling has
a leak.
3. Insufficient pressure set
on the pressure regulator.
P a g e
POWDP7070
Cause
non-return valve
POWDP7070
40V
-1
3000 min
8 bar
5 l
36 l/min
10 kg
87 dB(A)
97 dB(A)
| 10
Solution
1. Check the rechargeable
batteries.
2. Never operate with an
outside temperature
below +5°C.
3. Allow the motor to cool
down. If necessary, remedy
the cause
overheating.
1. Have a service center
replace the non-return valve.
2. Check the seals and have
any damaged seals replaced
by a service center.
3. Check the drainage cock
and replace if necessary.
1. Check the compressed air
hose and tools and replace if
necessary.
2. Check the
coupling and replace
necessary.
3. Increase the set pressure
with the pressure regulator.
www.varo.com
EN
of
of the
quick-lock
if