Bauknecht DDB 7760 Benutzerhandbuch Seite 16

DESCRIPTION AND USE OF HOOD
Control panel
1. OFF / Extraction speed (power) decrease button
2. ON / Extraction speed (power) increase button
Note: The higher speed (booster power) is timered and lasts 5 min (indicator c
flashes) then hood returns at speed (power) 2.
3. Timer ON/OFF button: delays deactivation of the selected extraction speed (power) by 5 minutes.
Note: The button also has the "Reset filter saturation signaling" function
4. Light ON/OFF button
5. Display, shows:
a. Extraction speed (power): the indicator rotates according to the selected extraction speed (power).
Safety operation: the indicator flashes.
b. Grease filter saturation: comes on when filter maintenance is required.
c. Timer
d. Active carbon filter saturation: comes on when filter maintenance is required.
Note: This function is normally disabled and should only be activated if the hood is used as a filter version (with carbon filter fitted).
To do so, proceed as follows:
- switch off the hood
- keep the buttons 1 and 3 pressed at the same time until the indicator goes from flashing (indicator disabled) to fixed light (indicator enabled).
- release the buttons.
To deactivate it, repeat the procedure: the indicator will go from fixed light (indicator enabled) to flashing (indicator disabled).
e. Lighting
Safety operation
The hood has a sensor which, in case of a sudden increase in temperature, activates extraction until the temperature drops significantly.
Filter saturation signaling reset
After carrying out filter maintenance, keep the button 3 pressed until the indicator goes off.
1. Control panel.
2. Grease filters.
3. Halogen lamps.
4. Telescopic flue.
GB14