level one EAP Serie Schnellstartanleitung Seite 5

English
Web Management Interface Steps:
1. Enter the AP IP address "http://192.168.1.1" in the address field. (Figure 1-1)
2. Enter the username "admin" and the password "admin". Click Enter to log in.
(Figure 1-2)
3. After a successful login into AP, a System Overview page of web management
interface will appear. (Figure 1-3)
Change Administrator's Password:
1. Click on the Utilities-> Change Password tab, enter the old password and
then a new password in the Password field, and re-enter it again. Click Save
to save the changes. (Figure 2-1)
Configure General AP settings:
1. Click on the Wireless-> General tab. Select your preferred Band and Channel
for you wireless connection. (Figure 2-2)
Configure VAP Profile settings:
1. Configure VAP profile settings：
(a) Select the Wireless->VAP Config tab to configure the settings of the
desired VAP.
(b) Enable a specific VAP from the drop-down menu of Profile Name and
configure related settings below. (Figure 2-3)
2. After finishing VAP configuration, the status of enabled Virtual APs shall be
reflected on the VAP Overview page. (Figure 2-4)
5