Appliance Equipment; Installation - Bomann Gt 7355 Bedienungsanleitung, Garantie

Unpacking the appliance
• Remove the appliance from its packaging.
• Remove all packaging material, such as foils, filler
and cardboard packaging.
Dispose of packaging materials that are no longer
required in accordance with the locally applicable
regulations.
• To prevent hazards, check the appliance for any
transport damage.
• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
"Cleaning and maintenance"
according to chapter

Appliance Equipment

Appliance Overview
Delivery scope
1x freezing basket, 1x ice scraper
.
1 Integrated
lid handles
2 Freezing basket
3 Temperature
control
4 Water discharge
opening
Conditions for the installation location
• Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 50～70 mm, to the
-
side walls each approx. 100 mm;
Place the appliance so that the appliance lid
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
The climate class can be found under
data"
and on the rating label located in the interior
or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Leveling the appliance
The feet can be used to compensate for slight une-
venness in the floor.
Check whether the appliance is leveled horizontally.
If the unit is not in balance, the feet must be ad-
justed.
19

Installation

"Technical