Ronix 2221 Bedienungsanleitung Seite 19

- When drilling masonry, set the hammer-drilling switch to hammer drilling.
- When using the machine as a screwdriver, set the hammer- drilling
switch to drilling.
- Set the direction switch to the correct direction.
- Never change the direction of motion when the machine is switched on.
CARE OF THE TOOLS
OVERLOAD
Never use excessive force when drilling. Too much pressure reduces
the speed of the machine, and the required power is greatly reduced.
This may result in overload, which can damage the motor of the drilling
machine. When the drilling machine becomes too hot, allow it to run for
two minutes without a load and then interrupt working for a short time. Clean
the drilling machine with a clean cloth and a brush. Ensure that the ventila-
tion slits are not blocked.
WARNING!
Always use the additional grips which come with the appliance. Losing
control of the appliance may result in injuries.
17
User Manual