Troubleshooting - Sentinel Bm-50 Installationsanleitung

MORE INFO
For details on pairing Bluetooth devices, troubleshooting, CZone integration and other
application notes, see http://www.sentinelmarine.net/boat-monitor/docs/
INSTALLATION COMPLETE
To power up the device for the first time insert the fuse on the supply wire (see fig. 2.2). The
device should power up and LED should light up. When the subscription is active it takes
approximately 1 minute until LED lights up green. This pattern signals normal operation.
In case of issues first check the device LED.
LED Status
Device is unable to
connect (SIM inactive, no
Red
coverage, communication
issue)
Device is registered to the
network but cannot send
Yellow
data (low signal, network
problem)
Device is up and running
Green
normally
Blinking
GNSS (GPS) signal is low or
(any
non-existent
color)
Changing
Device busy
colors
* If the device LED is off, check the fuse and make sure the power supply to the device is
higher than 12V! If the issue cannot be resolved, contact Sentinel support by using the
report issue feature built into the Sentinel application.

3. Troubleshooting

Action to be taken
Check subscription, make sure there is
cellular coverage. If no issue can be detected,
contact support via the mobile app.
Wait a few minutes, make sure cellular signal
is sufficient for normal operation. If no issue
can be detected, contact support via the
mobile app.
No action needed
Device is unable to acquire current position.
Check for metal objects obstructing the sky
view of the device and/or move the device to
another location.
Wait for the color to turn red/yellow/green
15