Power Supply Connection - Sentinel Bm-50 Installationsanleitung

Typical installation block diagram for BM50 PRO is shown below:

2.4 Power supply connection

To ensure continuous monitoring, the device should be connected to a constant
power source. When connecting any power or voltage input directly to the battery, it is
important to protect the battery and electrical circuit from potential damage by installing
a fuse holder with a 1 A fuse on the positive (+) power cable as close as possible to the
battery terminal.
Connect the red wire through a fuse (fuse should not be inserted until installation is
complete) to permanent power source (battery).
Connect the BLACK wire to system ground.
Works with Sentinel
GPS
(optional)
3rd party
products
CAN2/NMEA2000
Wired inputs
2.4
LTE
SENTINEL
BM-50 Pro
MFD
NMEA 2000
11
Sentinel companion app
NOTE! This is available to
professional users only!
Engine
Depth,
Digital
wind,
gateway
switching
temp.
Backbone