Herunterladen Diese Seite drucken

Parkside Performance PPSK 40 A2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung Seite 20

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 25
z Maintenance and cleaning
z Maintaining the burner
Switch off the main power supply and the main switch of the device prior to carrying out maintenance or
repair work on the plasma cutter.
The consumables displayed in Figure F are the electrode
They can be replaced once the nozzle clamping sleeve
The electrode
must be replaced if there is a crater of approximately 1.5 mm depth in the centre.
8d
ATTENTION: To pull the electrode out, do not apply irregular pressure, gradually increase pressure
until the electrode comes out. Then insert the new electrode into the holder.
The burner sleeve
must be replaced if the central bore is damaged or if it has expanded in compari-
8c
son to the bore of a new nozzle. If the electrode
this can result in the parts overheating. This can reduce the lift cycle of the diffuser
Once replaced, make sure the nozzle clamping sleeve
ATTENTION: The nozzle clamp sleeve
been equipped with the electrode
If these parts are missing, the device may malfunction and it may create a hazard for
the operating personnel.
z Maintenance
PLEASE NOTE: The plasma cutter must be regularly maintained for perfect function and to comply
with the safety requirements. Improper and wrong operation may cause failures and damage to the
device. Repairs must only be carried out by qualified specialists.
Switch off the main power supply and the main switch of the device prior to carrying out maintenance or
repair work on the plasma cutter.
z Cleaning
Regularly clean the outside of the plasma cutter and its accessories. Use compressed air, cotton
waste or a brush to remove dirt and dust.
In case of a defect or a necessary replacement of equipment parts, please contact the appropriate
qualified personnel.
z Storage
If you will not be using the device for a while, protect it from dust by storing it in a clean and dry place.
z Information about recycling and disposal
DO NOT DISPOSE OF ELECTRICAL TOOLS IN HOUSEHOLD WASTE! DON'T
THROW AWAY – RECYCLE!
According to European Directive 2012/19/EU, used electrical devices must be collected
separately for environmentally compatible recycling or recovery. Electrical and electronic
20
GB/IE/NI/CY/MT
or the burner sleeve
8d
must only be screwed on to the burner
8b
, diffuser
and burner sleeve
8d
8e
, diffuser
and the burner sleeve
8d
8e
has been unscrewed.
8b
are replaced too late,
8c
is tightened sufficiently.
8b
.
8c
.
8c
.
8e
once it has
8

Werbung

loading

Diese Anleitung auch für:

383214 2110