Panasonic CF-VDR721 Bedienungsanleitung Seite 8

Using the Drive
Using the Drive in the MS-DOS Mode
Ur BE)
To use the drive in the MS-DOS mode, configure the drive following the steps below after
performing the preparations (P page 6). If the steps listed below are performed with-
out completing the preparations first, the drive will not operate properly. j
1 Click the [Start] button then select {Shut Down].
2 Select [Restart in MS-DOS mode] and click [OK].
E 3 od CEnter) the "CONFIG.SYS" file for editing by issuing the following commands:
cd \(Enter )
edit config.sys
4 Move the cursor to the line containing "OAKCDROM.SYS" and delete the characters
"rem" at the beginning of the line. (Deleting "rem" causes the item to become valid.)
DEVICEHIGH=CAWINDOWS\COMMAND\OAKCDROM.SYS /D:MSCD000
(If this line is missing, add it.)
5 Press (Alt ) +Œ) ‚then($) to save the file. Then press +CF), then (X) to
exit the Edit program.
6 Follow the same steps to edit the "AUTOEXEC.BAT" file.
edit autoexec.bat
7 Move the cursor to the line containing "MSCDEX.EXE" and delete the characters "rem"
at the beginning of the line. (Deleting "rem" causes the item to become valid.)
LOADHIGH CAWINDOWS\COMMAND\MSCDEX.EXE /D:MSCD000 /L:L
(If this line is missing, add it.)
8 Press (Alt) +Œ) ‚then CS) to save the file. Then press +CF), then (X)to
exit the Edit program.
9 Restart the computer.