Overview Of The Components; Instruction Manual - Clatronic FS 3261 Bedienungsanleitung

General Safety Instructions
Read the operating instructions carefully before putting the
appliance into operation and keep the instructions including the
warranty, the receipt and, if possible, the box with the internal
packing. If you give this device to other people, please also pass
on the operating instructions.
• The appliance is designed exclusively for private use and for
the envisaged purpose. This appliance is not fit for commer-
cial use. Do not use it outdoors. Keep it away from sources
of heat, direct sunlight, humidity (never dip it into any liquid)
and sharp edges. Do not use the appliance with wet hands.
If the appliance is humid or wet, unplug it immediately.
• When cleaning or putting it away, switch off the appliance
and always pull out the plug from the socket (pull the plug
itself, not the lead) if the appliance is not being used and
remove the attached accessories.
• Do not operate the machine without supervision. If you lea-
ve the room you should always turn the device off. Remove
the plug from the socket.
• Check the appliance and the cable for damage on a regular
basis. Do not use the appliance if it is damaged.
• Do not try to repair the appliance on your own. Always
contact an authorized technician. To avoid the exposure
to danger, always have a faulty cable be replaced only by
the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
• Use only original spare parts.
Children and Frail Individuals
• In order to ensure your children's safety, please keep all
packaging (plastic bags, boxes, polystyrene etc.) out of their
reach.
WARNING!
Caution! Do not allow small children to play with the foil
as there is a danger of suffocation!
• This device is not intended to be used by individuals (includ-
ing children) who have restricted physical, sensory or mental
abilities and/or insufficient knowledge and/or experience, un-
less they are supervised by an individual who is responsible
for their safety or have received instructions on how to use
the device.
• Children should be supervised at all times in order to ensure
that they do not play with the device.
18
05-FS 3261_rewe.indd 18

Overview of the Components

1 Lid
2 Housing
3 VACUUM Control lamp „Suction"
4 SEAL Control lamp „Heat-sealing"
5 Suction nozzle
6 Heat-sealing wire
7 Heat-sealing foil
Not shown
Cable take-up
Initial Operation
• Remove all the packing material from the interior
• Take the adhesive strips off the foil roll.
1. Insert the mains plug into an AC safety socket, 230 V,
50 Hz (diagram A).
2. In order to form a bag from the roller foil, unroll the required
part of the foil (max. 29 cm) (diagram B) and separate this
by heat-sealing (diagram C+F).
3. Fill the bag.
4. Remove the remaining air out of the bag by suction and then
heat-seal it.
Removing Air by Suction
• Open the lid and place the suction nozzle in the bag. The
top and bottom of the bag must be lying flat on the foam
material edge next to the suction nozzle (diagram D).
• Close the lid and press only the left edge of the lid down. Air
is now sucked out of the bag (diagram E).
CAUTION: Ensure that no liquid is sucked up.
Heat-sealing
• Press down the lid on both sides. The red control lamp for
„VACUUM" and the green one for „SEAL" illuminate.
• As soon as the green control lamp goes out the lid may
be opened. The heat-sealing operation is now complete
(diagram G).
• Gently release both parts of the foil from the heat-sealing
wire (diagram G).
CAUTION:
Short-time operating: The device should only be left
switched on for 13 seconds. This should then be followed by a
break of at least 90 seconds.
Cleaning
• Always remove the mains plug before cleaning and wait until
the device has cooled down.
• Do not use any wire brushes or other abrasive objects.
• Do not use any acidic or scouring agents.
WARNING:
Under no circumstances should you immerse the device in
water to clean it. This could cause an electric shock or fire.
15.09.2009 9:16:05 Uhr