Herunterladen Inhalt Inhalt Diese Seite drucken

Anti Calc System; Anti Drip System - Zeegma Ironee Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 11
3. Set the temperature control knob to the steam position (fig. 4), selecting
EN
a range suitable for the type of fabric.
4. Wait until the iron plate heats up and the light indicator turns off.
5. Set the steam control knob to the desired position, adjusting the amount
of steam according to the type of fabric.
Note! Steam ironing is only possible at higher temperature settings. Otherwise,
water may leak from the machine.
STEAM EJECTION FUNCTION
1. Place the device in a horizontal position. Fill the water tank (see: Filling
the water tank). Place the device in a vertical position.
2. Set the temperature control knob to the "MAX" position.
3. Wait until the iron plate heats up and the light indicator turns off.
4. Press the steam ejection button (B, fig. A). Pressing the button several
times beforehand may be necessary to prepare the machine for operation.
5. Wait a few seconds for the steam to penetrate the fabric before
pressing the button again. For maximum efficiency, it is recommended
not to use this function more than three times in a row after the light
indicator turns off.
The steam ejection function is particularly helpful in removing stubborn
creases. It can be used for both steam and dry ironing.

ANTI CALC SYSTEM

Anti Calc is a system located inside the water tank that eliminates impurities
from the water and reduces the problems of scale accumulation. To prolong
the effectiveness of this system, perform the following steps periodically:
1. Unplug the iron from the power supply and let it cool down.
2. Fill the water refill container to about ¾ of its capacity. Add 1 teaspoon
of salt to the water and fill the water tank with the prepared solution.
3. Leave the solution in the water tank for 15 minutes, shaking it gently
from time to time, and then pour out the solution.
4. Fill the water tank a second time with the salt water solution, shaking it
occasionally, and empty it again after 15 minutes.
5. Fill the tank with fresh water to rinse it, and then pour out the water.

ANTI DRIP SYSTEM

Anti Drip is a system that constantly controls the flow of water to the iron
plate. Below a certain temperature, the anti drip function interrupts the water
flow and prevents water from dripping onto the fabric.

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Zeegma Ironee

Inhaltsverzeichnis