Docrooup DS2 Bedienungsanleitung Seite 7

Cruise Control
Cruise Control will be triggered when you holding thumb throttle for 8 seconds,
and it will be released by braking/pedaling
Hand Throttle Control
In the hand throttle mode, amount of power assist is determined by the throttle
switch controlled by your right hand. You control the throttle by twisting it from its
resting position, the farther the throttle switch is from its resting position, the more
power is delivered to the motor to accelerate the e-bike When you want to slow
down, you simply release the throttle and let it return to its resting position, and
simultaneously apply the brakes if necessary
You do not need to pedal the e-bike if you use the hand throttle. However, you
can pedal while commanding power assist. If you do pedal to help the
movement, you conserve energy and the charge in the battery will last longer.
Charging Your e•Bike Battery
Your e-bike battery is a lithium-ion battery. Lithium-ion battery requires specially
designed chargers. You should never charge your battery with a substitute
charger that is not designed for this use. Use of an unsuitable charger to charge
a lithium-ion battery will result in overheating, fire or even explosion. Ensure
charger voltage is consistent with battery voltage. If your charger is lost or
damaged, contact your dealer to order a replacement.
Charge your battery while the e-bike is not in use. You should turn off the battery
before you charge it. You may charge your battery while it is mounted on the e-
bike, or after it has been removed
Do not place either the charger or the battery near flammable substances while
charging is taking place. Charging should not be done in the vicinity of infants
and small children. It is also prudent to remove valuable objects from the
immediate vicinity of the battery while it is being charged. Don't charge in
unattended condition for a long time. For the safety of you and your family, it is
recommended not to charge in the middle of the night.
In order to maintain battery life, do not charge until the battery completely
discharged , it is recommended to start charging when the power is less than 20
percent.lf the battery will not be used for an extended period of time,charge it
fully and recharge it every month. If not used for several months, the battery may
be completely self-discharge and unable to charge.
The length of charging time depends on the level of charge the battery still holds.
If a battery is completely discharged, it will take 6 hours to be fully recharged.
When a battery is fully charged, the LED on the charger will transition from RED to
GREEN. At this point, you should disconnect the charger. Do not leave the
charger connected to the battery for a very long period of time after charging is
complete (Leaving it connected for an overnight charging is 0K.)
It is normal for the charger and the battery to be slightly hot while charging is on-
going.
11
11
or throttling
from the e-bike
Removing the Battery from the e-Bike
The battery is an important and costly part of the e-bike. It is designed to be locked
into position with a key to preventing theft You can take further precaution by
removing the battery while the e-bike is parked unattended.
need to remove the battery from the e-bike to recharge it at a location where you
cannot park your e-bike.
The method to remove the battery is:
Open the cap of the charging port and fold the bike;
II. I nsert the key into the battery, hold pressing the key a bit until twist clockwise
to the end (Note: You can't remove the battery until the lock bar withdraws into
the battery completely);
Slip off the battery, the battery is quite heavy and you should take care not to
drop it.
Maximizing the Riding Range
Many factors affect the rate of use of the electrical energy and the riding range
You should fully charge the battery before a long journey.
Rough road conditions and hilly terrain will consume more energy
Frequent change of speed will consume more energy
Carrying more weight on the e-bike will consume more energy
Keeping the tires properly inflated and keeping the e-bike clean
and well lubricated will save energy.
Making sure that both wheels move freely when brakes are not applied will
save energy. You should check brake adjustments frequently.
Pedaling as you ride will consume
riding range
When the battery is turned off, your e-bike functions as a regular bicycle
If you embark on a very long journey, you might want to turn off the
battery for long stretches where the road is level or downhill and pedal the
e-bike as a regular bicycle so that you can conserve
stored in the battery
You may also have a
less electrical energy and increase the
electrical energy
12
12