Lay-Z-Spa Xtras Bedienungsanleitung

The Comfortable, Affordable, Go-Anywhere Spa!
1
The Lay-Z-Spa™ should not
be set up or left out in
temperatures lower than
4˚C (40˚F).
Hibernate Function:
11
After 72 hours of operation (except timer
function), the pump will hibernate and "END"
will be displayed on the LED. When the pump
is hibernating both the rapid heating and water
filtration functions are disabled. To re-active
the pump simply press any button on the
control panel.
10
All Spas require the use of
chemicals in order to keep
the water clear and safe.
™
™
RESET
TEST
2
The PRCD plug must be tested
before each use to avoid risk of
electric shock. Do not use the
pump if this test fails.
12
IMPORTANT NOTICE:
This unit will automatically lock
after 5 minutes of inactivity.
13
To unlock simply place a finger
over function button
We recommend you take a shower
for 3 seconds. before using your Lay-Z-Spa, as
cosmetic products, lotions, and other
residues on the skin can quickly
RESET
9
If the pump is not heating properly,
please press the thermal cut-out
manual "Reset" button
on the pump.
Congratulations on the purchase of your new Lay-Z-Spa™.
Before operating the Lay-Z-Spa™ be sure to follow these 14
steps. Damage resulting from misuse is not covered by the
manufacturer's warranty.
MAX
MIN
Water
3
Level
Fill the water level between
4
maximum and minimum
printed on the SPA wall.
14
degrade water quality.
8
Change the Filter Cartridges
regularly.
Remove Stopper Caps
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
removed.
5
Be sure to set your desired
6
Check to ensure the Spa and
adapters are not leaking.
7
Clean and maintain the Filter
Cartridge regularly.
temperature.
1
S-S-005325