Lay-Z-Spa Xtras Aufbereitung

The Comfortable, Affordable, Go-Anywhere Spa!
1
The Lay-Z-Spa™ should not
be setup or left out in
temperatures lower than
4˚C (40˚F).
Hibernate Function:
11
operation (except timer
After 72 hours of
function),
the pump will hibernate and "END"
will be display on the LED. When the pump is
hibernating both the rapid heating and water
filtration functions are disabled. To re-active
the pump simply press any button on the
control panel.
10
All Spas require the use
of chemicals in order to
keep the water clear and
safe.
303021185650/28.5x21cm/54112,54113,54123,54129,54148,54154,54171,54175,54183,54186,54189/欧规SPA快速操作14步骤说明书插页/JS-YF-2017-B-05208/英
™
Congratulations on the purchase of your new Lay-Z-Spa™.
Before operating the Lay-Z-Spa™ be sure to follow these 14
steps. Damage resulting from misuse is not covered by the
™
manufacturer's warranty.
RESET
TEST 3
2
The PRCD must be tested before
each use.
12
13
IMPORTANT NOTICE:
This unit will auto lockout after
We recommend you take a shower
5 minutes of inactivity.
before using your Lay-Z-Spa, as
To simply place a finger
cosmetic products, lotions, and other
over function button
residues on the skin can quickly
for 3 seconds.
degrade water quality.
9
8
If the pump not heating properly,
please press the thermal cut-out
manual "Reset" button on
the pump.
MAX
MIN
Water
Level
Fill the water level between 4
maximum and minimum
printed on the SPA wall.
Ensure water is circulating between
the Spa and the Pump and that the
Stopper Caps have been
14
7
Clean and maintain the Filter
Cartridge regularly.
Change the Filter Cartridges
regularly
Remove Stopper Caps
removed.
5
Be sure to set your desired
temperature.
6
Check and ensure the Spa and
adapters are not leaking.
1
303021185650