Lomography Lomourette Half Frame Anleitung Seite 12

Installing the Battery and Using Flash
Slide open the Flash Battery Door
1. Install one AA battery (1.5 V) into the battery chamber.
2. Close the Flash Battery Door [13].
3. Switch on the Flash using the ON/OFF switch [14], and wait until
the Flash Ready Indication
4. Press the Test Button
now ready to install the flash onto the camera.
Troubleshooting
1. My daytime shots are really washed out and blurry!
Ah, you are most likely shooting with the "B" shutter setting by accident. Be
sure to use "N" for daylight.
2. My nighttime shots are really blurry and insane!
For sharp long exposures, you need to keep the camera as steady as pos-
sible. Try popping your Lomourette down on a flat surface and if there are
no flat surfaces in sight, try holding your breath and pressing your camera
against your face to keep it steady.
3. My daytime images are really dark!
Get faster film. You'll need full sunlight to shoot ISO 100 or slower on the "N"
setting.
My images are overlapping each other!
4.
[13] located at the bottom of the flash.
[15] lights up red.
[16] to make sure that the Flash works. You're
12 / ENGLISH