Maintenance - HEATSTRIP Rev C NOV13 Bedienungsanleitung

Safety
®
HEATSTRIP Max has an IP rating of X5. This means it is safe for water ingress from all directions. The HEATSTRIP
can be safely hosed down.
®
HEATSTRIP has undergone extensive testing both in laboratory conditions; in Thermofilm's manufacturing facility in
Melbourne and field trials in Australia, Europe and overseas. It has been this testing that gives the purchaser the
confidence of a high quality product.
Independent laboratory testing has confirmed full compliance with Australian and other International Standards. This
includes CE, AS/ANZ, UL/CSE
The heater comes in both plug (2400W) and hardwired (3600W) versions. In both cases the fixed wiring must be installed
by a licensed electrician in accordance with the relevant wiring regulations.
®
HEATSTRIP is Class 1 equipment and must be earthed.
In operation, this heater is VERY HOT— do not touch any part of the heater while it is turned on. Do not touch any part
until 30 minutes after it is turned off.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or intellectual
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety. Children should be supervised to ensure they do not play with the
appliance.
Do not allow any cables, furnishings, flammable materials or other items come in contact with any surface of the heater.
If installed in wet areas, the heater switches or controls must be located so that they cannot be touched by persons in the
bath or shower.
The heater needs to be installed as per the installation instructions paying special attention to the minimum clearances.
The heater needs to be mounted on a rigid bracket or fixing.
The heater must not be mounted immediately below or in front of a socket outlet.
In case of a heater fault or damaged supply lead, the appliance should be returned to the point of purchase for return to
Grand Hall Europe B.V. for repair.

Maintenance

®
The HEATSTRIP is made from durable materials, however regular care and maintenance of your heater will help prolong
the life of the heater.
It is recommended that you hose down the heater and with a soft cloth gently wipe the surfaces of the heater with a mild
detergent to remove the built up contaminants from the environment. Then rinse all detergent off the heater.
All chemicals in the atmosphere including cigarette smoke, pollution etc. will tarnish the surface of the heater. In this case,
additional cleaning and maintenance may be required. The cleaning process at least every three months will reduce the
amount of build up and keep it looking as best it can. If the heater is in a corrosive environment eg. salt spray, we
recommend that you clean your heater with a light spray of fresh water every week. After cleaning, turn the heater on for
20 minutes to dry any water residue and prevent water staining.
Before cleaning or inspection activity, the heater must be switched off and cooled down completely.
Do not use any abrasive materials or products to clean the heater, this includes solvents, citrus based cleaners or other
harsh cleaning products.
When handling the heater, ensure that your hands are clean or that you use clean gloves as grease or dirt can mark the
surface of the heater.
Do not use high pressure water to clean heaters, light water spray only.
R A D I A N T
16
O U T D O O R H E A T E R S
®