Sweet Protection Falconer Aero 2Vi MIPS Bedienungsanleitung Seite 7

s not
rized
ccidents.
speed can
our head. It
mn, or other
his helmet
oint that
s. This
it should
carded
other
s.
mountain
ights,
uct is
eliminate all
his helmet
ption in the
191002_sweet_AW2021_User_Manual_Looper_ENG.indd 7
FITTING THE HELMET:
1. Putting on the helmet: Align the front rim of the helmet above your
eyebrows. Hold the straps on both sides and roll the helmet over the back
of your head. Make sure the front is low against the forehead; otherwise no
gap between the helmet and your eyebrows. Once the helmet is on, the next
against the forehead with no large gaps. The back of the helmet should not
cover the nape of the neck. Make sure the helmet is positioned all the way
down on the head.
2. Fit test: Gently roll or lift the helmet off your head. If the skin on your
3. Proper use: Always adjust and secure the chin strap buckle before use.
Adjust the straps to retain the helmet in place. Finally, adjust the two-point
the same tension. Checking the straps: Grab the helmet with both hands
the extent that you can, forwards and backwards. IMPORTANT! If you can
push your helmet so far forward that your view is obstructed or so far back
back to sections 1 and 2 and repeat the steps for adjusting the helmet. Make
sure that your helmet feels comfortable. Go out and enjoy the ride!
NOTE:
shape of the helmet and the shape of your head. If so, you may have to try
NOTE:
1. Before each use of this helmet, make sure that no parts are broken,
cracked, torn, worn or missing.
2. Please treat this helmet as a personal item and avoid lending it to others.
3. Replacement: This helmet is made to absorb some of the potential energy
of a blow. Even though damage may not be visible or apparent, it is imperative
to discard and replace any helmet that has sustained a major impact in
an accident, or has received a similarly severe blow. An inspection of the
helmet might not reveal any apparent damage, but it might be there. Sweet
Protection also advise that any helmet should be replaced after approximately
three years of normal use, or sooner if exposed to long periods of sun, hard
use, or any contact with chemicals. The helmet must also be replaced if it
4. For cleaning, use clean water (max temperature 30°C) and mild detergent
only. Leave to dry naturally and not in contact with direct heat or on a hot
surface.
chemicals and other solvents that may drastically reduce the protection
provided by this helmet.
6. The helmet will be damaged if exposed to temperatures exceeding 62°C
(approx. 150°F). Do not leave the helmet in a car (or similar) in hot weather,
as it may easily exceed this temperature. If exposed to such temperatures,
the helmet must be immediately discarded and replaced.
7. The helmet will not perform as intended if you modify or replace any of the
original elements included in the helmet. Please note that any customizing is
not recommended,
7
15/11/2019 10:21