Additional Functions; Configuration - Tecnosystemi Pico Basic Benutzerhandbuch

•

Additional functions

You can access the following functions by long-pressing some keys or by a combination of one or more of them.
FUNCTION
Filter maintenance reset
Switching the LED on/off
Enabling / Disabling the WiFi

Configuration

72
DESCRIPTION
When the device reaches 1500 hours of operation the red LED blinks (2
s on - 2 s OFF) to indicate that the filters need to be cleaned.
Clean the filters as indicated in the Maintenance Chapter.
Switch off the device by pressing the key
Press and hold the key
When the counter has been successfully reset, the red LED turns off.
From the factory the LED indications of the device are always active and
correspond to the mode colours (example: removal = green).
To enable the LED OFF function LED, simultaneously press the key
(MAXIMUM speed)for 6 s
and the button
WARNING: switching off the LED does not prevent the device
from signalling filter maintenance.
Your device must be switched on for you to enable / disable.
Simultaneously press the "MODE" key and the switching on key
6 s .
The LED on the device blinks and a long beep sounds to confirm that
WiFi is enabled/disabled.
If a MASTER/SLAVE system is configured, the WiFi is temporarily disa-
bled, it is re-enabled at the first mode change.
To disable the WiFi, you need to disconnect the SLAVE device and con-
nect it as the MASTER.
To enable the function, simultaneously press the key
(MINIMUM speed) for 3 s
.
for at least 6 s to reset the counter to zero.
.
.
per
and the button